Loctite Lb 8065 C-5a Copper Quickstix Compound Anti-seize 20g

Loctite Lb8065 C-5a Copper Quickstix Compound Anti-seize 20g

• Color : Copper
• Curing Type : Non-curing
• Application : Lubrication

 

LOCTITE® LB 8065 is a copper colored, naphthenic oil, anti-seize in the form of a lubricant stick. All mated parts, studs, bolts, flanges and gaskets, remove more easily and in cleaner and better condition. This product can be used on copper, brass, cast iron, steel, all alloys including stainless steel, all plastics and all non-metallic gasketing materials.

• Typical applications include original equipment and maintenance, and equipment associated with petroleum chemicals, steel mills, power plants, marine motorering and foundries
• Typically used in applications up to +982°C
• Provides a shield against high temperature seizing and galling

LOCTITE®
LB 8065™ provides a shield against high
temperature seizing and galling. All mated parts, studs, bolts,
flanges and gaskets, remove more easily and in cleaner and
better condition. This product can be used on copper, brass,
cast iron, steel, all alloys including stainless steel, all plastics
and all non-metallic gasketing materials. Typical applications
include original equipment and maintenance, and equipment
associated with petroleum chemicals, steel mills, power plants,
marine and foundries. This product is typically used in
applications up to 982 °C.

TYPICAL PERFORMANCE

An anti-seize lubricant used on a bolt helps to develop greater
clamp load for the same torque compared to an unlubricated
bolt. An additional benefit is greater uniformity in clamp load
among a series of bolts.

GENERAL INFORMATION

This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected
with a sealant for chlorine or other strong oxidizing
materials.
For safe handling information on this product, consult the
Safety Data Sheet (SDS).

Directions for use

1. For best performance the mating surface should be clean
   and free of grease.
2. Note: When grinding or wire brushing, use a dust
   mask. Dust from cleaning threads may contain metal
   compounds. Inhalation may cause lung injury or other
   harm.
3. Apply thin coating to threads and flats of nuts and bolts,
   assemble.

Loctite Material Specification

LMS dated November-13, 2002. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality.

Storage

Store product in the unopened container in a dry location.
Storage information may be indicated on the product container
labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
Corporation cannot assume responsibility for product which
has been contaminated or stored under conditions other than
those previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.