Crc Urethane Seal Coat Spray 300ml Clear

Crc Urethane Seal Coat Spray 300ml Clear

CRC Urethane Seal Coat is an excellent adhering one component polyurethane coating. Its abrasive resistant insulation acts as a protective film. CRC Urethane Seal Coats are stable single component polyurethane coating that dries fast, adheres well and forms a hard, durable, flexible and non-conductive film.

Features:

• Red or clear available in two conformal colours
• Protection offers protective resistance to shocks, abrasion and aggressive chemicals
• Humidity and salt spray resistant provides heavy corrosion protection to preserve and lengthen useful life of equipment

Application:

• Recommended for protecting components from condensation & moisture, protecting printed circuit boards, insulates cables & wires, coating terminal strips, screw connections and switch boxes that are exposed to atmospheric effects, coating for electric motor windings, armature coils, commutator ends, transformer ends, coating for housings & bus bars and protective coating for tools Recommended for electrical and electronic applications.

Specification:

• Brand: CRC
• Product Type: Penetrant
• Appearance: Colourless Or Red Film
• Flash Point: 43℃ Open Cup
• Specific Gravity: 0.86 ± 0.02
• Weight: 300 ml
• Colour:Clear

Directions

• Shake well before and during use.
• De-energise; DO NOT use on energised equipment
• Mask area not to be sprayed.
• Best results are obtained when sprayed above 150
  C. Spray from a distance of 30
  to 45cm in light, even coats.
• Additional coats for additional protection may be applied after each coat dries.
• Allow 30 minutes drying between coats to facilitate build up.
• When finished spraying, clean valve by turning can upside down and pressing
  actuator until only propellant escapes.

Disposal

Disposal requirements vary by state and local regulations. All used and unused
product should be disposed of in conformance with local, state and commonwealth
laws and regulations.

Special Use Warnings

Aerosol Cans

Do not puncture, incinerate or store above 500
C. Exposure to high temperatures may
cause can to burst. Do not place in direct sunlight or near any heat source. Aerosol
cans will conduct electricity. Keep away from all live electrical sources including
battery terminals, solenoids, electrical panels and other electronic components.
Failure to observe this warning may result in serious injury from flash fire and/or
electrical shock.

General

Use only in well ventilated area. Ventilation may be improved by opening a window or
door or providing mechanical assistance. Avoid continuous breathing of vapour and
spray mist. Avoid contact with the skin and eyes. If ventilation is not adequate,
respiratory protection should be worn. For more information regarding short term and
long term exposure, review this product’s Material Safety Data Sheet.