Loctite Lb 8023 Marine Grade Anti-seize 8oz

Loctite Lb 8023 Marine Grade Anti-seize 8oz

• Color : Black
• Curing Type : Non-curing
• Application : Anti-seize

 

LOCTITE® LB 8023 is a black, metal-free, brush top lubricant and anti-seize made from graphite, calcium, boron nitride and rust inhibitors. ABS approved, it protects assemblies from fresh and salt water. It works especially well in high humidity conditions. It has excellent lubricity , superior water wash-out spray resistance and prevents galvanic corrosion. High temperature resistance to 1,315°C.

• Metal-free
• ABS approved
• Temperature resistant to +1,315°C
• Fresh & salt water/high humidity resistance
• Excellent lubricity and superior water wash-out spray resistance
• Prevents galvanic corrosion

LOCTITE®
LB 8023™ features a formulation that protects
assemblies exposed to direct or indirect fresh or salt water and
high humidity conditions. Typical marine applications include
bolts, screws, studs, pipe joints, nuts, shafts, bushings, splines,
chains, and cables. Other applications include pulp and paper
mills, water and waste water treatment plants, and dressing for
water pump gaskets and flanges. This product is typically
used in applications with an operating range of -29 °C to
+1315 °C.

TYPICAL PERFORMANCE

An anti-seize lubricant used on a bolt helps to develop greater
clamp load for the same torque compared to an unlubricated
bolt. An additional benefit is greater uniformity in clamp load
among a series of bolts

GENERAL INFORMATION

This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected
with a sealant for chlorine or other strong oxidizing
materials.
For safe handling information on this product, consult the
Safety Data Sheet (SDS).

Directions for use

1. For best performance the mating surface should be clean
   and free of grease.
2. Clean parts with a wire brush prior to application of
   product.
3. Apply thin coating to mating surfaces, assemble.
4. Do not use thinner.
5. Keep container tightly closed when not in use

Loctite Material Specification

LMS dated September-01, 2000. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality.

Storage

Store product in the unopened container in a dry location.
Storage information may be indicated on the product container
labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
Corporation cannot assume responsibility for product which
has been contaminated or stored under conditions other than
those previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.