Loctite Grade a Threadlocker Letter 50ml

Loctite Grade a Threadlocker Letter 50ml

• Strength : High
• Viscosity : Low
• Color : Red
• Curing Type : Anaerobic
• Application : Threadlocking

LOCTITE® Letter Grade A(088) Wicking GradeHigh StrengthThreadlockeris used to lock and seal fine threaded nuts,bolts and studs in a wide variety of applications. Note:This is a regional approval. Please contact your local Technical Service Center for more information and clarification.
LOCTITE® GRD A™ is used to lock and seal fine threaded
nuts, bolts and studs in a wide variety of applications

Mil-S-22473E

LOCTITE® GRD A™ is tested to the lot requirements of Military
Specification Mil-S-22473E. Note: This is a regional approval.
Please contact your local Technical Service Center for more
information and clarification.

ASTM D5363

Each lot of adhesive produced in North America is tested to
the general requirements defined in paragraphs 5.1.1 and
5.1.2 and to the Detail Requirements defined in section 5.2.

GENERAL INFORMATION

This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidizing materials.
For safe handling information on this product, consult the
Safety Data Sheet (SDS).
Where aqueous washing systems are used to clean the
surfaces before bonding, it is important to check for
compatibility of the washing solution with the adhesive. In
some cases these aqueous washes can affect the cure and
performance of the adhesive.
This product is not normally recommended for use on plastics
(particularly thermoplastic materials where stress cracking of
the plastic could result). Users are recommended to confirm
compatibility of the product with such substrates.

Directions for use

For Pre-assembled Threaded Parts with Thru Holes:

1. Prior to assembly, clean all threads (bolt and hole) with a
   LOCTITE®
   cleaning solvent and allow to dry.
2. For Thru Holes, apply several drops of product at screw
   and body juncture.
3. Avoid touching the bottle tip to the metal surface.

For Assembly

1. For Blind Holes, apply several drops of the product
   down the internal threads to the bottom of the hole.

For Porosity Sealing

1. Clean area and apply localized heat to the area to
   approximately 121°C.
2. Allow to cool to approximately 85°C and apply the
   product.

For Disassembly

1. Apply localized heat to nut or bolt to approximately
   250 °C. Disassemble while hot.

For Cleanup

1. Cured product can be removed with a combination of
   soaking in a LOCTITE®
   solvent and mechanical
   abrasion such as a wire brush.

Loctite Material Specification

LMS dated September-01, 1995. Test reports for each batch
are available for the indicated properties. LMS test reports
include selected QC test parameters considered appropriate to
specifications for customer use. Additionally, comprehensive
controls are in place to assure product quality and
consistency. Special customer specification requirements may
be coordinated through Henkel Quality

Storage

Store product in the unopened container in a dry location.
Storage information may be indicated on the product container
labeling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or
greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during
use. Do not return product to the original container. Henkel
Corporation cannot assume responsibility for product which
has been contaminated or stored under conditions other than
those previously indicated. If additional information is required,
please contact your local Technical Service Center or
Customer Service Representative.